disconnect time

[islam.irshaid]

Dear Experts,

Can I increase time between digits (disconnect time) .

That will be if dialing any external number (PSTN Number) such as 00962777556669 and I stop dial the digits after 7 digits (dial 009627 and stop) so I will get a disconnect message. So how I can increase this time??

Thanks

[paolo bevilacqua]

Thais is called interdigit timeout. Which system do you have exactly ?

[islam.irshaid]

Hi,

No i didn't mean the interdigit timeout( T302).

i need the disconnect time.

look if i dialed 5 digits of any external number 0XXXXXXXXXXXXXX,then wait for 6 second i will get voice message telling me that number error.

thats i need , to change this time ....

can help me ?

[islam.irshaid]

we have CCM5-Version: 5.1.2.1000-11

[Rob Huffman]

Hi Islam,

I'm going to have to go with my friend Paolo on this one (no surprise :) I think you and I were working on this recently and tweaked the T302 Timer to alleviate a Number Plan overlap. But this is also the Timer at play in this scenario;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc0072c/0#selected_message

In order to allow sufficient time for a user to dial a telephone number, Cisco CallManager relies on a timer referred to as the interdigit timeout. This parameter indicates the duration Cisco CallManager waits after each digit is entered before it assumes the user has finished entering digits.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00800dab26.shtml

Hope this helps!

Rob