Door Entry System

[jwcasey007]

Hello All -

We have a customer who runs a clinic where he needs a door latch system.  The client will NOT have a pager at the door - the receptionist will need to physically see the patient walk to the door, then "Buzz" it open.

We can permantly designate a button for this feature if needed.

They have a 12V Electric Door Strike installed.  Does anybody have a config or experience with this that they can share?

[paolo bevilacqua]

Any device made to be connected to an FXS port will work.

In other words, any device made for any PBX will work.

[jwcasey007]

I see you posted this on another similar Q:

http://www.sandman.com/pdf/Page40.pdf

Would this DTMF relay allow me to program a particular button on the specific phone to always open the door WITHOUT an intercom device?

[paolo bevilacqua · Accepted solution]

As indicated above: YES.

Or you can use and intercom device and simply leave the voice portion disconnected.

Please remember to rate useful posts clicking on the stars below.

[jwcasey007]

Paolo,

we got the Viking RC3:

http://assets.twacomm.com/assets/pdf/4378.pdf 

What we need to know now is:

I have it to the point where the Viking RC-3 answers, but it then beeps twice and waits for the caller to enter digits to trigger one of the three relays..  I'm requesting from Cisco TAC that they provide a way for the UC540 to delay sending digits until after the Viking device answers