How can I Clear the counters for the command "sh dial-peer voice xx" ?

[admin_2]

some time is usefull put in "zero" the counters how can i do that?

7200_TLALPAN_VOZ#sh dial-peer voice 166

VoiceOverFRPeer166

information type = voice,

description = `',

tag = 166, destination-pattern = `66',

answer-address = `', preference=0,

numbering Type = `unknown'

group = 166, Admin state is up, Operation state is up,

incoming called-number = `', connections/maximum = 0/unlimited,

DTMF Relay = disabled,

modem passthrough = system,

huntstop = disabled,

in bound application associated: 'DEFAULT'

out bound application associated: ''

dnis-map =

permission :both

incoming COR list:maximum capability

outgoing COR list:minimum requirement

type = vofr, session-target = `Serial2/2:1 26',

called number = `',

session-protocol = cisco-switched,

fax-rate = 7200, payload size = 20 bytes

fax NSF = 0xAD0051 (default)

codec = g729r8, payload size = 30 bytes,

signaling-type = cas,

VAD = disabled,

Voice Sequence Numbers = disabled,

voice class perm tag = `'

Time elapsed since last clearing of voice call statistics never

Connect Time = 11707, Charged Units = 0,

Successful Calls = 5, Failed Calls = 6, Incomplete Calls = 0

Accepted Calls = 0, Refused Calls = 0,

Last Disconnect Cause is "15 ",

Last Disconnect Text is "call rejected (21)",

Last Setup Time = 54031449.

[fbahram]

The only way to clear those stats is either

Reload the router

Or

copy the dial-peer to clipboard, delete the dial-peer and reconfigure the dial-peer.

The stats update for each call and the Last Disconnect Cause is always most recent call's disconnect. No other way that I believe you can clear them.

Hope this helps.

[gnasses]

A follow up since this is the first link on Google and the answer below is not correct. It took some looking, but you can clear these.

clear statistics dial-peer voice xxx

[Aman Soi]

Hi,

U can refer the link

https://supportforums.cisco.com/discussion/11478466/trying-reset-dial-peer-counters

regds,

aman