cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2282
Views
0
Helpful
4
Replies
Highlighted
Beginner

How to configure Cisco ISR 4321 as SRST

Hi to all!.

 

I have to configure a Cisco ISR 4321 Voice Gateway as SRST for a CUCM in a central Site.

 

This Router will handle a E1 and will be connected to Central PUB & SUB CUCM with SIP trunk.

 

Could you guide me to me how to configure this feature and all tips regarding that configuration please?

 

I configured Cisco Voice gateway between Asterisk PBX, but not yet with CUCM. 

 

Thanks in advance.

 

Kind Regards.

 

4 REPLIES 4
Highlighted
VIP Collaborator

Re: How to configure Cisco ISR 4321 as SRST

The 4000 series SRST configuration isn't really all that different than a 2900/3900.

You have to be running SRST 8.6 or higher, but if you have a current IOS you are fine there.

Check here for the Admin/Config guide:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cusrst/admin/sccp_sip_srst/configuration/guide/SCCP_and_SIP_SRST_Admin_Guide.html

License Part Numbers can be found here:
https://www.cisco.com/c/en/us/products/collateral/unified-communications/unified-survivable-remote-site-telephony/data_sheet_c78-678873.html

Highlighted
Beginner

Re: How to configure Cisco ISR 4321 as SRST

Dear Maren,

 

              Many thanks por your quick response.

 

I am confused about this options and I dont know if I have to use or don t:

 

Should I use this ?  srst mode autoprovision-none 

or should I use this? srst mode autoprovision all

 

Thanks in advance.

 

Kind Regards.

 
 
Highlighted
VIP Collaborator

Re: How to configure Cisco ISR 4321 as SRST

You want auto-provision all.

 

As the wording implies, this allows SRST to automatically provision phones that come to it for SRST services. If you use auto-provision none, you would have to manually pre-configure all phones that would require SRST services. That is used in an E-SRST environment, or if you are running CME in SRST mode so that you can pre-configure some or all phones with specific services and features during an SRST event.

 

HTH

Highlighted
VIP Collaborator

Re: How to configure Cisco ISR 4321 as SRST

I should mention there are additional considerations with regards to what information is saved in your running-config if you do a wr mem during or after an SRST event.

 

There is a longer discussion of this on:

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/cmeadm/cmesrst.html

 

Look at both the command-syntax section and the discussion further down the page.

CreatePlease to create content