cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
687
Views
0
Helpful
5
Replies

Voice sip configuration for 4451 router

joel.a.elias
Beginner
Beginner

Hello all,

 

I currently have a challenge. I am in the process of upgrading a 2911 router to 4451 to enable WAN throughput capabilities. 
I realised the new 4451 is not licensed accordingly to support voice and sip configuration.


Could anyone advise if i will require additional hardware to enable the voice commands ?

 

thanks in advance!

 

Joel

 

2 Accepted Solutions

Accepted Solutions

Nipun Singh Raghav
Cisco Employee
Cisco Employee
You need "uck9" license to use the voice feature set on the IOS first thing. Post this if you need to use a TDM to IP termination, you would need DSP's as well which are hosted on a PVDM card.
If this will be used as a CUBE or IP to IP GW, then you don't need any DSP's but would required CUBE RTU licenses.

Nipun Singh Raghav
"We cannot solve our problems with the same thinking we used when we created them"

View solution in original post

Right. uck9 would be a physical/hard copy license that you would need to install on the router. For CUBE license, these are honor based/paper license only. You need to pay for the CUBE feature.

Nipun Singh Raghav
"We cannot solve our problems with the same thinking we used when we created them"

View solution in original post

5 Replies 5

Nipun Singh Raghav
Cisco Employee
Cisco Employee
You need "uck9" license to use the voice feature set on the IOS first thing. Post this if you need to use a TDM to IP termination, you would need DSP's as well which are hosted on a PVDM card.
If this will be used as a CUBE or IP to IP GW, then you don't need any DSP's but would required CUBE RTU licenses.

Nipun Singh Raghav
"We cannot solve our problems with the same thinking we used when we created them"

Thanks Nipun, Thanks for confirming that! 

Based on the configuration i am only doing pass through. Could you assist in confirming by reviewing the old router configuration ?

 

Attached.

 

Thanks in advance!

What do you mean by pass through ?

Nipun Singh Raghav
"We cannot solve our problems with the same thinking we used when we created them"

HI again! Further to my previous comment. 

Does that mean i will require 2 licenses ? 
uck9 and cube license ?

 

Thanks 

Right. uck9 would be a physical/hard copy license that you would need to install on the router. For CUBE license, these are honor based/paper license only. You need to pay for the CUBE feature.

Nipun Singh Raghav
"We cannot solve our problems with the same thinking we used when we created them"
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers