Is PSTN callerID (enabled, telco end) possible over FXO?

[8gsiaw]

Hi,

Just want to know if the callerID is enabled at the telco end and works on a standard phone will the same work over a fxo port?

port configs

!

voice-port 1/0/0

cptone GB

connection plar 01908601000

IDEAS PLEASE.

ring number 3

[apadayhag]

Hi,

I have configured caller-id with fxo-m2 and it works, provided that the line from the telco has enabled caller-id. Make sure to know the caller-id standard being used in your area because every cptone has different standards. By the way I'm using H.323 with CallManager 3.1, MGCP with CallManager 3.1 does not support caller-id.

Hope this will help.

Arvin

[kenjohnson]

We are using 3.1(4b) with MGCP over PRI on a 3662 router and caller ID is working pretty well. Outbound name and number work fine. Inbound number works fine, but not name - I am told that is a MGCP compatibility issue with certain types of Lucent switch signallings that will likely be fixed in an early patch following CM 3.3.

- Ken

Ken Johnson

Mgr. Network Services

LeTourneau University

http://www.letu.edu

---------------------------------

CIPTUG

Cisco IP Telephony Users Group

http://www.ciptug.org

[bphelps]

Caller ID also works with fxo-m1 cards.

I believe the command is something like:

voice-port 1/0/0

caller-id enable

[8gsiaw]

I currently do not have his command available in this image: c2600-is3x-mz.122-13.T.bin. This FXO card VIC-2FXO-M2.

What IOS image are you running?

Thanks,

George.

[tringwelski_2]

you need IP Plus ios, and you can run debug vpm signaling, and look to ensure the telco is sending caller ID and Name info.