03-15-2007
11:52 AM
- last edited on
03-25-2019
06:54 PM
by
ciscomoderator
Anyone know if you can light a line button (i.e. on a 7961/41/70/71) through either AXL or a service URI
03-22-2007 10:13 PM
Unfortunately that's not possible. I remember asking Cisco about this and was told it would be implemented in a future release, but as far as I know, nothing has been done (and it has been about 2 years since I asked).
06-08-2007 07:05 AM
Any news on this yet ?
I am looking fot a application that will notify the IP Phone agents if they are not ready for more that 2 minutes on the phone.
or light p the button if they are not ready
J
06-09-2007 01:50 PM
I would suggest blink the MWI light. I had a similar application and that was the only way I could do it. They wouldn't accept a blinking image on the IP Phone.
10-08-2007 06:59 AM
Hi Mark,
Can you share the application that you used for the blinking MWI?
Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide