03-15-2007 11:52 AM - last edited on 03-25-2019 06:54 PM by ciscomoderator
Anyone know if you can light a line button (i.e. on a 7961/41/70/71) through either AXL or a service URI
03-22-2007 10:13 PM
Unfortunately that's not possible. I remember asking Cisco about this and was told it would be implemented in a future release, but as far as I know, nothing has been done (and it has been about 2 years since I asked).
06-08-2007 07:05 AM
Any news on this yet ?
I am looking fot a application that will notify the IP Phone agents if they are not ready for more that 2 minutes on the phone.
or light p the button if they are not ready
J
06-09-2007 01:50 PM
I would suggest blink the MWI light. I had a similar application and that was the only way I could do it. They wouldn't accept a blinking image on the IP Phone.
10-08-2007 06:59 AM
Hi Mark,
Can you share the application that you used for the blinking MWI?
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: