08-14-2006 02:51 PM - edited 03-13-2019 02:36 PM
Hello Experts,
I am configuring a CME (3.3) with a 2811 Cisco router. All calls go through PSTN. There's 8 FXO ports for outgoing and incoming calls. I have a PVDM to configure for conference calls and need help to do so. Could you please send me the config or an example allowing me to do so. Your help is appreciated.
Thanks,
08-21-2006 05:29 AM
Here's a sample config:
voice-card 4
dspfarm (note already existing on the router)
dsp services dspfarm
!
sccp local Loopback4(or sccp local FastEthernet0/0
sccp
sccp ccm 161.16.140.46 priority 1
sccp ccm 161.16.140.44 priority 2
sccp mtp sessions 1
!
dspfarm transcoder maximum sessions 1
dspfarm confbridge maximum sessions 2
dspfarm connection interval 180
dspfarm
08-21-2006 06:27 AM
Since you are running 2811, you should have PVDM2. Check the section "Configuring Enhanced Conference and Transcoding" on this link
Regards,
Anup
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide