cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
675
Views
0
Helpful
1
Replies

Speed / duplex settings on 4400g

Ryan Nilsson
Beginner
Beginner

Is there any way to set the speed / duplex settings of the NIC on 4400g DMPs? I'm aware that gigabit interfaces have no duplex settings but if the device is connected to a 100 switch can the device be set to 100/full?

I cannot see any settings nor can I see any output from the MIBs indicating the current settings. If it cannot be set then is it assumed to be set to auto/auto?

1 Accepted Solution

Accepted Solutions

Marco Cassini
Cisco Employee
Cisco Employee

Hi Ryan,

Your assuption is correct. Speed/duplex are set to auto/auto on DMPs. This is not user configurable.

Regards,


Marco

View solution in original post

1 Reply 1

Marco Cassini
Cisco Employee
Cisco Employee

Hi Ryan,

Your assuption is correct. Speed/duplex are set to auto/auto on DMPs. This is not user configurable.

Regards,


Marco

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: