11-08-2007 03:39 PM - edited 03-15-2019 04:56 AM
I set the system clock to the correct time but the phones are showing 5 hours earlier. The display was right about a week ago then the vendor changed something and now I can't get the phones to read the right time. No matter what I set the system time to the phones never change. Is there a command to tell the phones what time to display and how do you set it?
thanks
11-09-2007 03:09 AM
Seems like the timezone is not set correctly
Have you checked the Date/Time-group in the callmanager?
11-10-2007 08:48 AM
Reset the IP Phone's respective Device-Pool, however be cautious when doing this depending on how many devices are registered at time.
If your large numbers of phones I would recommend this course of action is carried out of hours.
When the phone registers to CCM is should pickup the correct time. As a test you could perhaps reset one IP Phone, and when you are assured this works proceed to restart the others.
Regards
Allan.
Pls rate this post if you find it helpful
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide