UCS c220 M3 nic Redundancy

[ciscoceci]

Hello,

I am doing a fresh installation CUCM 10.x over UCS c220 M3. Anyone know if is possible use redundancy eth using the mother board nic for servers like CUCM, CUP? my suggestion is use one of it to configure redundancy for CUCM.

Thanks Anna.

[Manish Gogna]

Hi Anna,

Please check the following post for similar query

https://supportforums.cisco.com/discussion/12204511/ucs-network-card

HTH

Manish

[Aaron Harrison]

Hi Anna

Sure - you can just add multiple physical NICs to the switch in VMware. 

VMware will then fail over the VMs between the NICs as required.

Regards

Aaron