01-26-2004 07:18 AM - edited 03-13-2019 03:31 AM
I have following config;
Interface Loopback 0
ip address 192.168.200.1 255.255.255.252
!
Interface serial 0
ip address 192.168.12.5 255.255.255.252
!
Dial peer 0 pots
port 2/1
destination pattern 222
!
dial-peer voice 10 voip
destination patter 333
session-target IPV4:192.168.100.1
!
As I can see, the VoIP packets originated form the router, and leaving the WAN interface will have source address of Serial 0, ie 192.168.12.5.
Is ther any way that I can specify the Loopback ) address for Voip packets instead of serial 0 ?
01-26-2004 07:23 AM
Interface Loopback 0
ip address 192.168.200.1 255.255.255.252
h323-gateway voip bind srcaddr 192.168.200.1
01-27-2004 08:10 AM
!
interface Loopback0
ip address 192.168.200.1 255.255.255.252
h323-gateway voip interface
h323-gateway voip h323-id 192.168.200.1
h323-gateway voip bind srcaddr 192.168.200.1
!
dial-peer voice 10 voip
destination-pattern 333
progress_ind setup enable 3
session target ipv4:(ip address of CCM)
dtmf-relay h245-alphanumeric
codec g711ulaw
ip qos dscp cs5 media
no vad
!
HTH
Rob
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide