cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
9298
Views
0
Helpful
3
Replies
Highlighted
Beginner

nexus 5k vpc peer-switch command

I am using 5548 and 5596.

both are running

5.1(3)N1(1a)

According to VPC domain documentation, you want to issue the peer-switch command to ensure that both switches in the VPC domain are STP root

these switches do not have the peer-switch command available.

(config-vpc-domain)# ?

  auto-recovery             VPC settings to enable auto recovery if peer is presumed non-operational

  delay                     Initialization delay

  dual-active               Configuration when peer link is down but peer is alive

  graceful                  Enable graceful features

  ip                        Configure IP features

  ipv6                      Configure IPv6 features

  no                        Negate a command or set its defaults

  peer-config-check-bypass  Ignore type checks on primary, when MCT is down

  peer-gateway              Enable L3 forwarding for packets destined to peer's gateway mac-address

  peer-keepalive            Keepalive/Hello with peer switch

  role                      Role related configuration

  system-mac                Configure system mac address

  system-priority           Configure system priority

  end                       Go to exec mode

  exit                      Exit from command interpreter

  pop                       Pop mode from stack or restore from name

  push                      Push current mode to stack or save it under name

  where                     Shows the cli context you are in

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee
3 REPLIES 3
Highlighted
Cisco Employee
Highlighted

Not too familiar with the upgrade process on the nexus.  Will upgrading the NxOS affect my licensing?

Highlighted

It will not affect your existing licensing.

Regards,

jerry

Content for Community-Ad
This widget could not be displayed.