Nexus Data Broker Embedded

[kashif.kamal]

I have configured embedded NDB on a Nexus 93180YC-FX switch but when I try to add the same switch as a device in the NDB it is giving me error "Unknown Error", I am using the switch Management IP.

Also I am not sure if there is a license required to enable the Embedded NDB.

[Sergiu.Daniluk]

Hi @kashif.kamal 

What do you use for NDB? NXAPI or OpenFlow? is the feature enabled?

What version of NDB and NXOS you run?

Cheers,

Sergiu

[kashif.kamal]

Hi @Sergiu.Daniluk,

       Using NXAPI, NDB version is 3.9-k9 and the NXOS version is 9.3.3. Please have a look at the attached error.

“NXAPI Device 10.242.100.18 reloaded, credentials are correct, rediscover the device when all the Ethernet modules are up ”

Do you think it is due to the required subscription?

[Sergiu.Daniluk]

Can you share "show module" and "show run" from the switch?

Sergiu

[kashif.kamal · Accepted solution]

Hi thank you for your support. I have managed to make it work. I was missing the command

"nxapi http port 80", after configuring this command the broker connected successfully with the switch.