cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1297
Views
0
Helpful
4
Replies

Nexus Data Broker Embedded

kashif.kamal
Level 1
Level 1

I have configured embedded NDB on a Nexus 93180YC-FX switch but when I try to add the same switch as a device in the NDB it is giving me error "Unknown Error", I am using the switch Management IP.

Also I am not sure if there is a license required to enable the Embedded NDB.

 

 

1 Accepted Solution

Accepted Solutions

Hi thank you for your support. I have managed to make it work. I was missing the command

"nxapi http port 80", after configuring this command the broker connected successfully with the switch.

View solution in original post

4 Replies 4

Sergiu.Daniluk
VIP Alumni
VIP Alumni

Hi @kashif.kamal 

What do you use for NDB? NXAPI or OpenFlow? is the feature enabled?

What version of NDB and NXOS you run?

 

Cheers,

Sergiu

kashif.kamal
Level 1
Level 1

Hi @Sergiu.Daniluk,

 

       Using NXAPI, NDB version is 3.9-k9 and the NXOS version is 9.3.3. Please have a look at the attached error.

“NXAPI Device 10.242.100.18 reloaded, credentials are correct, rediscover the device when all the Ethernet modules are up ”

 

Do you think it is due to the required subscription?

Can you share "show module" and "show run" from the switch?

 

Sergiu

Hi thank you for your support. I have managed to make it work. I was missing the command

"nxapi http port 80", after configuring this command the broker connected successfully with the switch.

Review Cisco Networking for a $25 gift card