6509's MSFC BOOT IMAGE , CAT IOS AND MSFC IOS UPGRADE HELP NEEDED

[haseeb_eng]

Hello switching experts ,

I have 6509 switch . And i will upgrade it to 24 Mb flash (MEM-C6K-FLC24M) . And after that i want to install following software iamges on cat 6509 switch :-

IOS 12.1(19)E (c6msfc-dsv-mz.121-19.E1)

MSFC boot image upgrade to:-c6msfc-boot-mz.121-19.E1

CAT IOS for supervisor upgrade :-cat6000-supk8.7-6-1.bin

I think so i have to install 1st MSFC boot image , secondly Cat ios for supervisor engine and at the end MSFC IOS 21.1(19)E . If this is not the correct method then please tell me the proper way . And please give me a link which describes step by step method to upgrade these softwares .

[owillins]

The following 2 docs explain the procedure of the software upgrade for the switch and the L3 module.

http://www.cisco.com/warp/public/473/161.html

http://www.cisco.com/warp/public/473/129.html

[Prashanth Krishnappa]

I suggest that you boot from the MSFC bootflash. The MSFC bootflash which is 16MB cannot fit both c6msfc-boot-mz.121-19.E1 and c6msfc-dsv-mz.121-19.E1. But in 12.1(19)E1, you do not need the boot loader image even for a MSFC1. So, just copy the c6msfc-dsv-mz.121-19.E1 image to the MSFC and boot using it.

[cjrchoi11]

Hi,

.

Can you guide me based on our environment. supervisor-1A-2GE with MSFC1. the MSFC have 16M bootflash and 128M DRAM.

.

The current configuraiton on MSFC.

boot system flash bootflash:c6msfc-jsv-mz.121-11b.E12.bin

boot bootldr bootflash:c6msfc-boot-mz.120-3.XE1

.

can I upgrade to 12.1(19)E1a on the current enviroment with delete both current bootldr and IOS ?

.

Thanks,