I would like users to dialup without a username and password. If I configure no ppp authentication under the group-async, an ip address is assigned but I can not ping the dialed up PC.
I have configured DDR(ISDN)Idle timeout,but inspite of intersting traffic the call disconnects after specified idle timeout & reconnects.This is with Cisco 2610 with IOS Version12.0(7).
i have a 2500 rtr dialing through the bri into the NAS(LAC) and forwarded from there on with l2tp to the home gateway(LNS).the bri is configured for chap and so is the vtemplate on the LNS side..(so a two way authentication). The LNS authenticates O...
I have a POP ISP site using AS5800 and AS5300 .one e1 controller on both the access servers is configured for E1 PRI.The ISP incharge complains that ISDN subscribers (using BRI connections to connect to the access server)complain of slower ISDN acces...
I have an AS5300 which dispatches accounting on Cisco Access Registrar. one of the account attribute is Acct-Terminate-Cause (attr 49). the attribute Reports details are explaining why the connection was terminated. Termination causes are indicated b...
The router details are:Router#sh verCisco Internetwork Operating System SoftwareIOS (tm) 3600 Software (C3640-IS-M), Version 12.2(1a), RELEASE SOFTWARE (fc1)Copyright (c) 1986-2001 by cisco Systems, Inc.Compiled Sat 26-May-01 00:55 by pwadeImage text...
I connect a PC via a modem to 3640 router. In the 3640 there are MICA modems. On the pc there is a program that sends data. When this data arriveson the tty line in the router I use the autocommand telnet 193.210.186.240 10300 /no echo to make a tcp ...
Each interface is a Channelized T1. My Utilization has jumped recently from an average of about 42 - 48% to an average of 58% peaking in the 70s. I am wondering if I am pushing the limits of the 3640. Two of my interfaces have 75 PVC each and one...
They have a drop and insert mux with a v.35 interface for data. They want to use some channels on the T1 for voice and the rest can be used for data. Is the wic-1t the right card?If so, does it just synch to the proper speed for whatever is being se...
How would I configure custom queuing for the following?IPX packet size 700 bytes 30%IP packet size 1400 bytes 25%DLSW packet size 500 bytes 45%Is there a formula for working out custom queuing problems like the above?
what is the order of a, b, c for an OSPF route to enter in the routing table? a) less cost, b) longest prefix, c) preffered path type ?In the Doyle book and RFC 2328 states that b is preffered, then c. In what point is looked at the cost?
We have remote pc's dialing into our internal network via a 3620 over a T1. We are having a problem wheresoftware on the pc's is continuallyattempting to make a connection to someinternet site to check for updates orsomething of the sort. This traffi...
the serial of the 3660 router go down and up, and it carries out this error:04:44:54: CIRRUS-5-LINEFLAP: Unit 5 excessive modem control changeswhat is this error?
