Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
537
Views
0
Helpful
5
Replies

Campus Manager not discovering swicthes connected to routers

etarento
Level 1
Level 1

‎08-30-2004 11:02 PM - edited ‎03-02-2019 06:07 PM

Solaris 2.8

Campus Manager 3.3 IDU 8.0

sho cdp ne on the router sees several switches but these ar not appearing in Campus Manager after the deault 2hr discovery polling cycle

Perhaps the line

Discovery.router=off

in

/opt/CSCOpx/campus/etc/cwsi/ANIServer.properties

has something to do with this

Labels:
0 Helpful
5 Replies 5

rmushtaq
Level 8
Level 8

‎08-31-2004 01:21 PM

In the ANI Discovery Settings, is the option 'Jump router boundries' enabled?

0 Helpful

etarento
Level 1
Level 1
In response to rmushtaq

‎08-31-2004 05:07 PM

No

0 Helpful

minie
Level 4
Level 4

‎08-31-2004 06:49 PM

You are correct. That means "Jump Router Boundry" is not checked, so discovery will stop at router boundry. Other than this and CDP enabled, also make sure snmp community is configured on switches.

0 Helpful

etarento
Level 1
Level 1
In response to minie

‎08-31-2004 10:26 PM

Thanks everyone, jump router boundaries did the trick

0 Helpful

etarento
Level 1
Level 1
In response to etarento

‎08-31-2004 10:28 PM

This presumeably means I can now seed CM with routers rather than switches. I'll try. Any thoughts?

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card