Other Network Architecture Subjects

Pl help,I haveing two router at same location 3640 & 2610xm with the configuration given below, in 3640 s1/3 (64kbps) and 2610xm s0/3:0(2048kbps) configured for remote location. at remote location both interface are connected at same router. when I ...

I have just purchased a Cisco 2500 series router (with 2 ethernet ports) for my home use. I understand that this is very odd & overkill for home but I am getting serious for my CCNA and feel that this will only help me by setting up a router at home ...

Hi all,I am correct in saying that SLB is only supported by the higher end Catalyst switches (6500 upwards) via service modules?If that is the case, is there any alternatives to achieve the same kind of thing with smaller switches, like 3750s? Specif...

Hello,I have a router that seems to have had its flash memory wiped and is stuck in the rommon prompt.I have a identical router which is working fine. Is there a way to transfer the file(s) I need from the rotuer that is working to the one that is n...

Why named access list not generally used in configuration instead of number ACLThanksSAM

Hi,1. Can u let me know that how many 2MB links can a cisco 7206 router be populated & its drawbacks2. Also the no of E3 card in cisco 7206 router3. Drawback / implication of populating the router with 2MB & E3 cardAs i had a req. from a client who n...

I have recently installed ISDN at my house and need to connect a non-Cisco FW. I am using a CISCO 801 to connect the ISDN to my network. Right now, the Cisco boxis acting at my gateway. My goal is to assign the FW an external ip and have it serve a...

I am configuring a new AS5350 with 1 E1 PRI to accespt analog and ISDN calls. The E1 controller is up with no alarms. The corresponding serial 3/0:15 is also up, up (spoofing). However, when I show isdn status, the layer 2 is at TEI_ASSIGNED state. D...

Hi,I have a question about EIGRP query sending. I have three routers running EIGRP, router B learns EIGRP routes from router A, and sends these routes to router C.In common case, router B should send query to router C for the routes learnd from route...

Can a Catalyst 4006 to work with AC, DC power supply in the same time ?

What is the minimun catOS needed for a Supervisor II (WS-X4013) in a 4006 Chassis for supporting the WS-X4548-GB-RJ45 line card. Is there any other requirement..? I'll appreciate your help

We have a bunch of switches(mostly 3550s) uplinked to a 6509. We just connected 4 new 3550s to the 6509, and some users on those switches are complaining of slow network connectivity.I looked on the 6509, and noticed that if you enter a show interfac...

I'm building a new network with 6509's and was wondering what the benefits are of running in either hybrid or native modes are. Which mode do you prefer? I talk to various Cisco SE's and get various answers. LOL

Hi Guys, Interested to see a response on this one. Spanning Tree Port Fast rules say that a switch port with port fast configured should never have a hub, switch, or router connected to it. However according to the 3550 Voice Vlan config guide http:/...

Hello,I'm trying to route Frame Relay in a test lab and have not been successful yet. I've got two 7206 routers, with IOS 12.0, and E1 serial cards. I've got the E1's cross connected with an RJ45 cable... link lights are good. I've setup each E1 as a...