Can´t get Apps-Data on NAM2

[marcel.leitel]

Hallo,

I have a cat6513 with NAM2. On Switch run´s native IOS version 12.1(13)E4 and on the NAM ist the Version 3.1.1a installed. And now my problem, i have established a span-session over the GUI. If I look after 1 hour in the MONITOR-TAB, there are no App´s Data available. The GUI print´s, that I establish a SPAN-Session.

Mini-Rmon is on every Interface enabled.

thanks for help

marcel leitel

PS: sorry for my bad english ;-)

[jomelros]

Hi,Marcel

If your NAM cannot do data capture using its

web interface, you may need to run this command

on the NAM to clean up the RMON table:

config clear

Did you span the ports to the NAM or any VLAn

spanned to the NAM ?

Please have a look at the following link:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/fam_mod/x6380nam/rel2_1_1/re2_1_ug/appxa.htm#49307

--) Check for the part

" Why am I having problems capturing packets, even

after I configured the capture settings in the

Capture Settings dialog box and clicked Start?"

Also here is how to configure the NAM and how to use the NAM web interface:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_10406.htm

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/sw_ntman/6000_nam/mod_app/index.htm

--> If it still doesn't work, then you may want

to try the following:

Try to configure a manual SPAN from the command

line of the switch " This is to see if that works fine."

Look into the following link on how to configure

it manually on the CLI of your Catalyst:

http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_configuration_guide_chapter09186a00800f4ff8.html#1024634

Best Regards,

Joseph Melrose

[marcel.leitel]

Hi, Joseph

thanks for the tip to clear the NAM-config. it function now proper.

After i cleared the config and established a new span-session, the nam get´s app´s data.

best regards from berlin/germany,

marcel leitel

[rmushtaq]

You have to turn on the collections first under Setup->Monitor for your span source, other wise you'll not see any data under Monitor screens.