Other Network Architecture Subjects

Dear Sir,I found the following error message when I consoled into the switchMay I know what is the problem?4w6d: %SW_VLAN-4-BAD_VLAN_TIMER_ACTIVE_VALUE: Encountered incorrect VLAN timer a ctive value: already active when started -Traceback= 283520 28...

In this case did Cisco Catalyst 6500+MSFC+PFC2 can do distributed links aggregation between 2 different Cat6 at core similer as XRN technology.

I've installed LMS 2.1 with CiscoView 5.4 and cat4000IOS device packageversion 4.1.Sometimes, when I select a cat4000IOS device, it appears in CiscoView withblank modules. I have other 450X which don't have the problem.I need to stop the daemon by ne...

Hi all,I need a solution for the following setup: async-------router---------------router-------async Terminal | 64kbps LL |Terminal (A) | IP Backbone | (B) rs232 r...

Hello,is it possible to make static routes on basic of the source route?we would like to configure load balancingbut the routing should be on basic of the source Addresses.thanks in advanceLorenz

I used solarwinds Syslog server on win2000 os , but I have not found a good tutorial. The Access mdb file increased day after day. Do you happen to know of a good link that might help me out? Thanks in advance.

I use the PIX to connect two broadband lines and one is designed for backup. I know that I can use the two default gateways and different metric to automatically failover to backup line when the primary line has problem in the CISCO router but I can ...

I want to runOSPF on our network instead of RIP2. Rip does not work correct. I have a private network but we are growing and OSPF is better. Comments , advice and how to's ...please thanksAl

I have two Internet-facing routers which are connected to each other via dual paths. An iBGP peering needs to be maintained between the routers. If the BGP peering is created with loopback addresses, is it permissible for the loopback addresses to co...

I have 2 1601, 3 2651 and 1 3640 routers all running RIP2 on a Private network. The RIP2 does not seem to work and there are not more than 15 hops. I want to migrate to running OSPF but I would like to get RIP2 working first. We are still using some ...

I would like to know what commands I can use to see who is on any of the 24 digital modems installed.I would also like to know who has been dialed in, like a history report for the last few days.ThanksT.M.

Anybody ever seen this problem?I have eigrp running on a cisco router with a default route configured out to my firewall. This router has stopped propogating the default route out to my remote sites over the WAN( Frame Relay). The eigrp neighbor re...

Hi all,hope I'm in the right Forum and that your keeping well. Can you please help Me? I'd like to know if it's possible and if so how to do the following;An email comes in via a Cisco Router's connection to the Internet, the email is then forwarded ...

hi,i want to log all the commands and the output that a user connected throw a vty (telnet/ssh) enters. Is it possible???i have a 3725 and 3550C