01-14-2021 07:42 AM
Looking for some guidance around the following setup:
We have two Cisco NGFW 2210 (running 6.6), and also have two ISPs (Comcast and AT&T). The HA pair are being managed by FDM (with no intentions of using FMC).
I have not seen any documentation that supports an active-active configuration based on current version (v6.6).
Has anyone setup these appliances with active-standby with FW1 (ISP1 + FW2 (ISP2).
01-14-2021 08:15 AM
FW1 (ISP1 + FW2 (ISP2). - no this is not possible high level - until you make them standalone mode
but you can do PBR to route the traffic to ISP1 and ISP2 to split the load between 2 ISP - is this works for you below guide help you :
https://www.youtube.com/watch?v=MKcSBTJ55e8&t=18s
01-14-2021 09:38 PM
01-18-2021 11:20 AM
I don't think this is possible as i have the same issue with my FP1010 (running 6.6), and also have two ISPs. if you have FTD managed by FDM (with no intentions of using FMC).
This is Cisco Bug note
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvb19682/?rfs=iqvred
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvo39894
This doesn't make sense at all to have a limitation for Dual ISP Load balance and failover,
Using Cisco its really strange
if you have any other suggestion please advise
01-18-2021 02:32 PM
I know FDM has limited features, only to manage certain features, For full working featured cisco suggesting FMC requirement.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide