03-11-2005 10:00 AM - edited 03-02-2019 10:06 PM
I am trying to make 2 2620's connect with MLPPP. The problem I am having is that 1 of the WIC interfaces goes into alarm mode after boot up.
When I boot up the router the second WIC will go into alarm mode and not pass traffic. If I then shut down the router and take out the first WIC, boot back up, the second WIC works fine. I can plug either circuit into the working WIC and get a connection to the other side. I have changed out the WICs. I have tried a different 2620 Chassis. I have tried using a 2610. I have tried 3 different IOS images c2600-i-mz.122-21b, c2600-ik9o3s3-mz.123-13, c2600-ik9o3s-mz.122-28.
I know the circuits are definetely good. I am wondering if there is a bug with these older 26X0 series routers that is causing this.
Any ideas?
03-11-2005 11:59 PM
When you issue a sh ver, do you see both wics installed?
Regards,
Juan-Pablo
03-12-2005 02:28 PM
Yes, both WICs show in a sh ver. I will be opening a TAC case on this Monday.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide