Does WS-X4232-GB-RJ support WS-G5483?

[api]

Hi, even I did research for about one hour I have not found any reliable information. Would be great to know.

Thanks in advance.

[glen.grant · Accepted solution]

Ws-G5483 must have code at version 7.2 or higher to work. shown is minimum and recomended versions.

WS-G5483=

1000BASE-TX GBIC

7.2(1)

7.4(3)

[api]

Thanks Glen, may you can send me the link? I need to know if CatOS 7.2 will run with 4003 because I have seen that it will work with 4503.

Regards from Munich, Germany

Axel

[Georg Pauwen · Accepted solution]

Hello Axel,

here is the link Glen was likely referring to:

Cisco Gigabit Ethernet Transceiver Modules Compatibility Matrix

http://www.cisco.com/univercd/cc/td/doc/product/gbic_sfp/gbic_doc/ol_6981.htm

Gruss,

GP

[api]

Well that's what I have found by myself. But only 4500 Series is shown with. May it depends on EOL of 4003. It's a very critical costumer so I wonna make 100% sure.

[glen.grant · Accepted solution]

The catalyst 4003 with a sup 1 or 2 supports 7.X code as long as you have enough dram (64 meg) and the rommon version is 5.4.1 or higher. Below is a blurb from the relaese notes.

roduct Number

(append with "=" indicates spares)

Product Description

Minimum Supervisor Engine Software Version

Recommended Supervisor Engine Software Version

Supervisor Engine

WS-X4012

Catalyst 4000 series Supervisor Engine I

4.5(8) minumum

7.4(3) recommended

WS-X4013

Catalyst 4000 series Supervisor Engine II, 2 GBIC ports, console port (RJ-45), management port (RJ-45)

5.4(2) for Catalyst 4000 series chassis minimum

7.4(1) for Catalyst 4500 series chassis minimum

7.4(3) recommended