EASY ONE - Multiple VLAN on interfaces

[edw]

Hiya,

I have a CIsco Cat 6006 and I want to have multiple vlans on a port. The vlans are setup and working finr and I can assign one to a port, I have trunking enable and this shows up okay on the ports conserned. However I do I get the port to have say VLAN 1 and 2 I presume the actual active vlan are the ones under the heading "Vlans allowed and active in management domain" after using show trunk command ??

ANy help much appreciated!

Ed

[glen.grant]

Show trunk will tell what vlans are allowed on the trunked interface .

[edw]

Hiya,

Yes but how do I add to the vlans allowed ??? If I use set trunk this adds allowed vlan but not active vlans ???

Does that make sense

Thanks

Ed

[scottosan]

switchport trunk allowed vlan remove *

switchport trunk allowed vlan add *

[edw]

Hiya,

Nice try but this is for Switches running the Cisco IOS - Im talking about the Catalyst 6006 running Cisco OS

Thanks

Ed

[Prashanth Krishnappa]

The following page should help

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_3/confg_gd/e_trunk.htm#wp1021347

[edw]

Hiya,

Thanks

That I dont quite understand is the following (Details have changed from the acutal)

Port Vlans allowed on trunk

-------- ------------------------------------------- 3/48 1-1005

Port Vlans allowed and active in management domain

-------- -------------------------------------------

3/48 231-234,264-267

How do I limit the vlans allowed on this trunk ? I dont want to affect any other ports thou ???

Thanks

Ed