Hi
So I had RTR setup on a Cat4000 running IOS 12.1.8a for measuring jitter between the 4000 and a 2621 at the remote site. I wanted to make a change to the frequency and the docs said that you have to kill the rtr schedule associated with the rtr process number...so I did a 'no rtr schedule 1' which said that I had to wait untill it cycled again, which I did, and when that was done, the schedule changed to pending instead of run now and when I try to do a 'no rtr 1' it takes the command, but if I do a 'show run' I still see rtr 1 and all its config still in the running config. If I try to configure rtr 1, it says "Entry already exists and cannot be modified". If I try to reschedule rtr 1, it says "RTR: cannot schedule entry which is being reset." I really need to get rid of this rtr 1, any ideas? Thanks
jason
