Error message on 6500 series: %SCP-4-DACK_TIMEOUT_MSG:

[p.abbeel]

Hi,

Since short I receive the following message once and a while.

Jun 29 09:03:27.459 CEDT: %SCP-4-DACK_TIMEOUT_MSG: SCP delivery ack timeout for opcode=11D

Jun 29 09:09:49.510 CEDT: %SCP-4-DACK_TIMEOUT_MSG: SCP delivery ack timeout for opcode=11D

According the Cisco.com Error Message Decoder: Error Message Decoder

1. %SCP-4-DACK_TIMEOUT_MSG: SCP delivery ack timeout for opcode=[hex]

This message indicates that the route processor did not receive SCP delivery acknowledgements from the switch processor after two retries. [hex] identifies the operational code.

Thanks for any insight about the cause I receive this? (hardware issue, software issue? something caused by a direct connected device?).

Peter Abbeel.

[Prashanth Krishnappa]

Can you paste output of sh mod from the Supervisor so that we get to know hardware type of Sup/MSFC and the CAT OS/IOS version you are running.

[p.abbeel]

(enable) sh mod

Mod Slot Ports Module-Type Model Sub Status

--- ---- ----- ------------------------- ------------------- --- --------

1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes ok

15 1 1 Multilayer Switch Feature WS-F6K-MSFC no standby

2 2 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes standby

16 2 1 Multilayer Switch Feature WS-F6K-MSFC no ok

3 3 48 10/100BaseTX Ethernet WS-X6348-RJ-45 no ok

4 4 48 10/100BaseTX Ethernet WS-X6348-RJ-45 no ok

6 6 24 100BaseFX MM Ethernet WS-X6224-100FX-MT no ok

8 8 8 1000BaseX Ethernet WS-X6408A-GBIC no ok

Mod MAC-Address(es) Hw Fw Sw

--- -------------------------------------- ------ ---------- -----------------

1 00-30-96-b0-92-1e to 00-30-96-b0-92-1f 3.3 5.3(1) 7.6(4)

00-30-96-b0-92-1c to 00-30-96-b0-92-1d

00-d0-01-53-2c-00 to 00-d0-01-53-2f-ff

15 00-d0-bc-f4-ab-6c to 00-d0-bc-f4-ab-ab 2.0 12.1(20)E 12.1(20)E

2 00-30-7b-91-10-26 to 00-30-7b-91-10-27 3.1 5.3(1) 7.6(4)

00-30-7b-91-10-24 to 00-30-7b-91-10-25

16 00-30-7b-91-10-28 to 00-30-7b-91-10-67 1.3 12.1(20)E 12.1(20)E

3 00-b0-8e-82-1b-64 to 00-b0-8e-82-1b-93 1.1 5.3(1) 7.6(4)

4 00-02-fc-60-6f-c0 to 00-02-fc-60-6f-ef 1.1 5.3(1) 7.6(4)

6 00-d0-d3-a5-07-8d to 00-d0-d3-a5-07-a4 2.5 5.4(2) 7.6(4)

8 00-01-97-25-05-8c to 00-01-97-25-05-93 2.0 5.4(2) 7.6(4)

Mod Sub-Type Sub-Model Sub-Serial Sub-Hw Sub-Sw

--- ----------------------- ------------------- ----------- ------ ------

1 L3 Switching Engine WS-F6K-PFC SAD04010BZX 1.0

2 L3 Switching Engine WS-F6K-PFC SAD041201C2 1.1

(enable)

[p.abbeel]

Hi,

Any news regarding this issue?

thanks a lot,

Peter Abbeel.