Failing with simplest NAT config ever

[guitar007]

I am using a Cisco 1921 with Gig0/0 and Gig0/1 interfaces on it.  I'm trying to do something really simple, however it isn't working at all and I feel I must be overlooking something very basic.

ip cef

no ip source-route

ip classless

!

interface GigabitEthernet0/0

  desc private internet

  ip address 192.168.116.1 255.255.255.0

  ip nat inside

  no ip virtual-reassembly

  speed 1000

  duplex full

  no mop enabled

!

interface GigabitEthernet0/1

  desc public internet  

  ip address x.x.x.244 255.255.255.240

  ip nat outside

  no ip virtual-reassembly

  speed 1000

  duplex full

!

ip nat inside source list 2 interface GigabitEthernet0/0 overload

ip route 0.0.0.0 0.0.0.0 x.x.x.241

!

access-list 2 permit 192.168.0.0 0.0.255.255

Packets in 192.168.116.0/24 get to Gig0/0 but don't get translated to go out onto the internet, so a ping to an address on the open internet fails but I can ping the .241 gateway. I turned on debug ip nat but it isn't showing anything useful. Any ideas on what I am overlooking?

Thanks,

CJ

[guitar007]

To clarify, I should have said:

"Packets in 192.168.116.0/24 get to Gig0/0 but don't get translated to go out onto the internet, so a ping to an address on the open internet fails. From the router, I can ping the .241 gateway."

CJ

[balaji.bandi · Accepted solution]

try this

config t

!

no ip nat inside source list 2 interface GigabitEthernet0/0 overload

ip nat inside source list 2 interface GigabitEthernet0/1 overload

!

end

[asimGurung]

Hi, maybe you could change the command "ip nat inside source list 2 interface GigabitEthernet0/0 overload" to use GigabitEthernet0/1 (the one pointing to the outside network) instead.

[guitar007]

Thanks, I could swear I tried that!  I can't believe I made sych a simple mistake. Thanks for the assistance.

CJ