09-10-2002 12:48 PM - edited 03-02-2019 01:15 AM
I am setting up a fractional T1 (512K) on a Cisco 2516 used as CPE. The "service-module t1 timeslots 1-8" option is not available there. Besides setting up the number of channels on the external DSU/CSU, is anything required on the router to specify a fractional T1 ?
Thanks.
Solved! Go to Solution.
09-11-2002 11:39 AM
The SERVICE-MODULE command is only for integrated/WIC CSU/DSUs. Since the 2500 series only has serial interfaces the "module" isn't present. All of your setup will be on the external CSU.
09-11-2002 10:32 AM
Nothing special on the router. Just make sure that you set a bandwidth statement so that your routing protocols (if applicable), and your show interface counters will function properly.
09-11-2002 10:32 AM
Nothing special on the router. Just make sure that you set a bandwidth statement so that your routing protocols (if applicable), and your show interface counters will function properly.
09-11-2002 11:39 AM
The SERVICE-MODULE command is only for integrated/WIC CSU/DSUs. Since the 2500 series only has serial interfaces the "module" isn't present. All of your setup will be on the external CSU.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide