11-20-2004 12:49 AM - edited 03-02-2019 08:05 PM
Here is the scenario :
Total of three sites as given below
- HeadOffice
- SiteA
- SiteB
Head Office is connected to SiteA and SiteB via Leased line. Isdn is used as a backup link but headoffice got only one ISDN line and siteA and siteB has there own ISDN line.
Q) Its very rare that both the sites (siteA and siteB) will go down simultaneously therefore i wanna know if its possible to use the only isdn line availabe at the headquater for supporting both(siteA and siteB) which has there own isdn lines . If yes then how and what will be a configuration example.
11-20-2004 01:12 AM
Hi
The same can be achieved by configuring different dialer interfaces and configuring the reqd infos to dial out & connect to the respective locations or else try creating simple dial in in the HO to accept the calls from the sites..
Do find the link which can be helpful to achieve the same..
http://www.cisco.com/en/US/tech/tk801/tk133/technologies_configuration_example09186a0080093c2e.shtml
regds
11-20-2004 05:04 AM
Dear Spremkumar,
The configuration file (link) was very helpfull and I learned alot from it. The bri configuration is almost done but via this configuration the isdn link will always be up. I wanna use the ISDN link to be up only when the leased line circuit is down, how would i do that ?
And also whats the specific link to on cisco site where i can get configuaration examples (similar to the one u gave me) because that link was a step by step configuration help.
Appriciated
11-21-2004 06:44 PM
hi
to activate the dialer incase of u r LL failure configure backup interface dialer 1 and backup interface dialer 2 under ur respective serial ports where ur site A and site B is getting connected.
also find the link from where u can chekout all the technologies being deployed by cisco..
http://www.cisco.com/pcgi-bin/Support/browse/index.pl?i=Technologies
regds
11-21-2004 09:22 PM
Hi spremkumar,
Thanks a million I think i am almost completed the task with ur help. If its possible can u send me a link for configuring backup link via dialer1 and dialer 2 in case LL fails. Thanks
11-22-2004 08:46 AM
To have bri come up ONLY when Serial is down, enter the following config on the serial interface or subinterface:
router(config-if)# backup delay 60 90
backup int bri0
!
end
<< 60 secs to come up & 90 secs to go back down>>
That's -of course- depend on ur network reqs.
hope that help
11-22-2004 09:31 PM
Dear Mohammed-khadr,
When my leased line fails i wanna bring up isdn link and that is gonna be done by the command u have told(backup delay 60 90) but i want the isdn link to be up untill the LL comes up and the link must switch from Isdn to LL automatically . R there any commands for that?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide