L3 Routing on 4006

[leowchongwei]

I have a WS4014 Sup III engine in the 4006 box. All along i thought 4006 is CLI based, but this one is a IOS based. Been trying to find info on how to get the routing done between VLANs but can't find one. Can anyone point me to the right direction?

[Prashanth Krishnappa]

After you create your Layer 2 VLANs, create a corresponding Layer 3 VLAN interface and assign it an IP address

http://cio.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_12/config/l3_int.htm

[leowchongwei]

Meaning there no need to do any routing configuration on my part? After L2 & L3 VLANs interfaces are created, the switch will auto-route?

[Prashanth Krishnappa]

To route between the VLANs locally, you do not need any routing protocol. It is similar to directly connected interfaces of a router. If you have another router and want to route to it, you'll need to use static routes/routing protocols