Mgnt IP address on 4506 w/ sup V

[alonzo-garza]

Hello all, I have two questions. The new 4506 SUP V engines don't have the good old SCO interface that I'm used to. So, since it's running an IOS now instead of the old CATos, I figured I'l create a new vlan and then make it the management IP address by using the 'MANAGEMENT' command (like in the old 2900's). Well, that didn't work either, so my question is...on what int. do I configure the mgnt. IP address?

-thank you....

[amikat]

Hi,

Just think of Cat4506 with SupV like being a router: Any L3 interface can be used for mgmt. This can be either physical with "no switchport" configured and IP address assigned or logical e.g. interface vlan (and IP address assigned).

Best regards,

Antonin

[Prashanth Krishnappa · Accepted solution]

Refer to the following tech tip

http://www.cisco.com/warp/public/473/8.html