Hi,
I've a chassis config for a service provides that use MPLS.
the question is: When do I need to use different kind of CFC,DFC and memory quantity for my modules ??
The chassis config is:
Cat 6509 NEBS Chassis for all Supervisors,No PS,No Fan 1 Unconfigured
S733ZK9M-12218SXD Cisco CAT6000-SUP720 IOS ADV IP W/MPLS/IPV6/SSH/3DES + BGP 1
WS-SUP720-3BXL Catalyst 6500/Cisco 7600 Supervisor 720 Fabric MSFC3 PFC3BXL 1
MEM-C6K-CPTFL256M Cat6500 Sup720 Compact Flash Mem 256MB 1
WS-SUP720-3BXL Catalyst 6500/Cisco 7600 Supervisor 720 Fabric MSFC3 PFC3BXL 1
MEM-C6K-CPTFL256M Cat6500 Sup720 Compact Flash Mem 256MB 1
WS-X6748-GE-TX Cat6500 48-port 10/100/1000 GE Mod: fabric enabled, RJ-45 1
MEM-XCEF720-256M Catalyst 6500 256MB DDR, xCEF720 (67xx interface, DFC3A) 1
WS-F6700-CFC Catalyst 6500 Central Fwd Card for WS-X67xx modules 1
WS-X6724-SFP Catalyst 6500 24-port GigE Mod: fabric-enabled (Req. SFPs) 1
MEM-XCEF720-256M Catalyst 6500 256MB DDR, xCEF720 (67xx interface, DFC3A) 1
WS-F6700-CFC Catalyst 6500 Central Fwd Card for WS-X67xx modules 1
GLC-SX-MM GE SFP, LC connector SX transceiver 24
FAN-MOD-09 Fan Module for CISCO7609 and Catalyst WS-C6509-NEB-A 2
PWR-4000-DC 4000W DC Powr Sup for CISCO7609/13, Cat6509/13 chassis 2
When do I need to use different kind of CFC,DFC and memory quantity for my modules ??
MEM-XCEF720-256M
Catalyst 6500 256MB DDR, xCEF720 (67xx interface, DFC3A)
( 1 ) MEM-XCEF720-512M
Catalyst 6500 512MB DDR, xCEF720 (67xx interface, DFC3A)
( 1 ) MEM-XCEF720-1GB
Catalyst 6500 1GB DDR, xCEF720 (67xx interface, DFC3BXL)
WS-F6700-CFC
Catalyst 6500 Central Fwd Card for WS-X67xx modules
( 1 ) WS-F6700-DFC3B
Catalyst 6500 Dist Fwd Card, 256K Routes for WS-X67xx
( 1 ) WS-F6700-DFC3A
Catalyst 6500 Dist Fwd Card for WS-X67xx modules
( 1 ) WS-F6700-DFC3BXL
Catalyst 6500 Dist Fwd Card- 3BXL, for WS-X67xx
