Received clockrate and WIC-1T

[cxantzis]

Is there a way to view the received clock rate when using a WIC-1T?

The command "show controllers serial" provides the info for the NM and PA modules but the output for the WICs is more cryptic...

[smif101]

I am 99% sure that you can not determine the clockrate coming into a serial interface for the cisco routers. I have never seen it in my testing but I hope someone out there has and provides us with that detail. The best bet has always been using a test set.

Jason Smith

www.smif101.com

[cxantzis]

Hello Jason and thanks for the prompt reply.

command:

show controllers serial 1/1 (PA-4T i/f running at 1024 Kbps)

line state: up

cable type : V.11 (X.21) DTE cable, received clockrate 1023606

What i am looking for is the eqiv. of this info for the WIC intefaces.

Chr.