Is there a way to view the received clock rate when using a WIC-1T?The command "show controllers serial" provides the info for the NM and PA modules but the output for the WICs is more cryptic...
We are planning to migrate from ATM back to Ethernet. We want to keep our network simple, rugged and robust, so that we have minimum maintenance/management hassles in the future. I have designed a preliminary draft of a network, that takes care of al...
I am replacing a linksys router with a Cisco 2610. The original setup is the linksys WAN interface is connected to a Toshiba cable modem. The Linksys LAN interface connects to a port on a BayStack 102 hub. All the computers plug in to all the othe...
I'm setting up a Catalyst 3750 and I'm attempting the configuration myself. I'm a beginner just getting started with Cisco products. The initial configuration went well. A Cisco reseller informed me that I should set up port fast on the switch. What ...
Hi folks, we've just got a 6509 chassis + Sup 720 and switching modules in- my task is to place a basic L2 configuration on it. My experience extends to Cat 19, 29, 35 range- this is a daunting beast!Anyway- I can get interfaces set up with addresses...
I'm migrating Cat6500 from CatalystOS to Native IOS. Is there any more conversion tool for config-file migatation? I think on CCO there was earlier that kind of tool but I can't found it any more.
pls, I have a 3600 + 1 fastethernet card, the router will reset when the router connected a 2950 or I config the fastethernet's subinterface .pls help me! and thank you !
I'm a installing one NCM for a client Demo.From this link I found that I need to contact TAC to get a license:http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/ncm/ncm1_0/ncm_lisc/ncm_lic.htmSince I've open a TAC case but still have no C...
hi,we have a 3640 router with 4 slots free. i have an NM 1E2W module inserted in one of the slots and in that NM 1E 2W i have inserted a WIC2T wan card. problem is that it is recoginising the NM Module while boot up but not the wic2t. i am not able t...
Hello everybody,After updateing IOSfrom: c1700-k9o3sv8y7-mz.123-2.XE.binto: c1700-k9o3sv8y7-mz.123-8T.binon a Cisco1760-V3PN/K9i can not save the running config. By console, by telnet ssh, by SDM 1.2IOS Message:myxx# copy runn startDestination filena...
For some reason the file "strtserv.bat" was not copied during the nGenius 1.4 install, therefore I'm unable to start the server up. Could someone please post/email a copy of, or the contents of their "strtserv.bat" file. The file belongs in the <nets...
We are planning to set up an ethernet network for our office. The primary network traffic consists of connections to the SAP server, Lotus Notes server and a few Intranet servers located centrally in the "IT Building". In the 4 LAN segments that we h...
Hi,I have 2x 2950 switch... Possible to do the following?Switch 1 - Port 24 destination port and cross cable to Switch 2 - Port 1 Switch 2 - Port 1 as a source port, and i will have a IDS Sensor at Switch 2 - Port 24 destination portWill the traffic ...
Say I have 3 switches all connected with redundant links. The switches converge for 30-50 seconds. During this time, will the devices on each switch still talk to the devices on the same switch, or, does EVERY port on the switch go into blocking? ...
