09-24-2019 01:38 AM
Hello Experts,
I could able to see many route-map when I give command sh route-map in CLI, but when I tried to see the running config I could able to see only 2 route-map that are bind to the BGP neighbor.
Is there any command to check where the route-map is bind with?
Thanks
09-24-2019 02:51 AM
Can you post the configuration here to confirm what route-map configured?
you can check
show run | in route-map
09-28-2019 06:45 AM
If you can post the configuration that will be great.
Meanwhile can you double check configuration was properly saved and Bind to BGP.
Please rate all helpful posts
10-02-2019 05:27 PM
Route maps can be used for many purposes beyond their use in BGP. Among their many uses would to to control redistribution in a routing protocol, to control address translation, to control Policy Based Routing. I do not know of any command that would identify how each route map is being used. The only way I know of to do this is to manually examine the configuration, finding each route map, noting the name of the route map and then looking in the config for where that name is used.
HTH
Rick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide