Router try to load old IOS after an upgrade

[kabdulla]

After upgrading flash memory and IOS on a 4700 M router, the router didn't load the new IOS. It is tring to load the old one which was deleted at the time of upgrade. Now I can only boot with bootflash. Please let me know how to set the correct path to new image to load. There are two partition in the flash. Partition 1 has the new IOS, partition 2 is empty.

[zujun.fan]

you could use a command to make the two partition into One!

[Erick Bergquist]

Did you have a 'boot system ...' command in the config with the old IOS filename? If so, you need to remove that from the cfg.

[glen.grant]

Get rid of the old boot system command and put in the new one pointing to the new IOS image and make sure to do a write mem otherwise it will just continue to try and load your old config .

[kabdulla]

Thank you all. It worked.

[vijayendra_sharma]

Hi Ka,

Where did you goofed Up ??

regards,

Vijayendra.

[mberrocal]

oops, problem already solved...