07-02-2006 09:41 PM - edited 03-03-2019 03:53 AM
Hi,
Does anyone know the correct way to configure a voice port on Cisco 3550? Cisco seem to use different config on every switch family.. it is a bit confusing..
eg: Voice vlan:100 with 802.1Q Frames, data vlan: 50.
it this the correct config??
!
interface FastEthernet0/10
switchport access vlan 50
switchport mode access
switchport voice vlan 100
spanning-tree portfast
!
also, how to config the switch if voice vlan use 802.1p Priority-Tagged Frames?
thanks
regards,
sean
07-02-2006 09:48 PM
I can go through the steps individually but I think it is more appropriate if you read it in detail from the relevant portion of the configuration guide:
If you still have specific questions we are here to help out.
07-02-2006 09:54 PM
Thanks. i have read the doco before.
my question is:
do i need to manually set the port to "access"? if yes, how does IP hone set the COS?
07-02-2006 10:02 PM
Hi
The switch is going to detect it through CDP and set the COS values.make sure u have enabled CDP on the ports.
Thanks
Mahmood
07-02-2006 10:18 PM
does it mean i only can use this config on Cisco ip phone?
could someone show me the 802.1p with data vlan switch configuration example. thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide