Dear People:)
I am about to finish my education and regarding that we are preparing a little setup.
This consists of 2 FW with a VIP and an internal network of 2 OSPF zones and 1 in DMZ, connected to 2 pcs of L3 switch.
We have to use OSPFv2 down...
ARE THERE ANY COMMANDS WHICH WILL GIVE THE CHASSIS SERIAL NUMBER AS OUTPUT, FOR ROUTERS? ALSO, IF ANYONE KNOWS A COMMAND FOR SWITCHES THAT WOULD BE HELPFUL.
Hello everyone,Many pages describing EIGRP say that one of used metrics is the interface MTU. However, the formula for calculating the composite metric does not take MTU into account so the MTU can not affect the composite metric of a route.I would l...
Hello, I have a difference between uptime and snmp uptime message.This problem points itself to different Cisco Komponenenten. On router and on Switche. failure message: The watch source value 3145251155 is greater than the threshold reference value ...
Hello,
I Request for Finding Cisco High Level Design Documents
about SD-WAN, Cisco NXOS VXLAN-EVPN deisgn
Any further recommanded deisgn document here?
THank you.
after configuring a password for the switch/router, I am unable to enter the password as it won't even display letters (when typing) onto the Command Line Interface. (I'm new to packet tracer so If it's really obvious what I did wrong, that's why)
I am new to Cisco Packet Tracer and I am trying to create a public IP address so it can be accessed from another building. When i use the command 'show ip nat translations', i can see the ublic IP i created. I added it on the DNS server but when I tr...
Hello,I'm still a bit of a noob when it comes to Cisco, so please excuse any seemingly trivial questions.I am asking this question since I was unable to find an complete und detailed guide how to build a three-tier network online.That's why I have so...
This is a bit of a weird one We have a large core rtr (Layer 3) doing all the Routing across our VLANS. We came into a situation where we lost core recently witch then meant that one of our vlans that has storage for a specific system went down badly...
Hello, I’m learning the basics of Cisco Packet Tracer and I tried to configure NAT. I want to set a public IP so that the other buildings can access the DNS server I created, but the problem is they can’t connect.
Hello great fellas of the Cisco Community! I had a little idea bouncing around in my head and thought I'd throw it out here. SO, what if we kicked off a weekly or monthly lab challenge? Could be built in EVE-NG, GNS3, CML, or whatever tools u vibe wi...
Hey everyone, I really need some help on this. No matter what I do, I cannot get this to work at all. Right now I have a NAS running a VM in which is running Microsoft Server 2016. It has an address of 10.0.0.247 and the NAS has an IP address of 10.0...
