can you help me to do Telnet to a router Cisco for UDP to port 500
Forum Posts
Hi, Im new to cisco and Im trying to set the default gateway from router, so the ICMP packages can be redirected. From the following image:I want Router 1 to set Router 2 as G.W.How do I configure Router 1's gateway?
Hi all, I have the following 2 issues, and i would like to know if they are related or not. 1.-This is for all the trunks ports, This is connected to wifi devices. Sep 28 12:34:10.041: %SW_MATM-4-MACFLAP_NOTIF: Host 08d2.3e08.e0e4 in vlan 667 is fla...
Hi.Hope you are doing great.I was working in a NCS-6000 and suddenly I realize that when I type the command CRP/0/RP0/CPU0:NCS#admin show install activeTue Sep 13 17:25:43.962 CDT% No entries found.Does not show the smus, but if apply the command:R...
Hello can someone tell me how do i make it so that a user can have access ,in one especific interface only, to modify that ip address and the description but NOT be able to do the shutdown command, and on the other interfaces ,the same user, only hav...
I bought this equipment and when it started it does not allow me access when configure terminal, it tells me command not supportedWhat could be happening?Best regards
