08-18-2005 05:52 PM - edited 03-09-2019 12:11 PM
Hi,
Adding a new FSWM interface
Currently on the Catalyst 6500, this is defined for the active FWSM
firewall module 1 vlan-group 1
firewall vlan-group 1 100,101
If vlan 102 is a new interface for the FWSM, by just entering the command below
will not cause any interruptions to the existing interface vlan 100 and 101.
firewall vlan-group 1 100,101,102
Please confirm.
Debug command
The debug and capture on FWSM do not seemed to work properly. Anyone know if there is a known bug on FWSM version 2.2(1)? If there is, is there a fixed yet?
TIA.
PF
08-18-2005 11:22 PM
Hi,
For adding vlan 102 there is no need to include VLANs 100 & 101 in the command as these were added already.
"firewall vlan-group 1 102" should add the new VLAN without any interruptions to VLANS 100 & 101.
HTH
Regards,
Shijo George.
08-21-2005 02:11 PM
Thanks Shijo.
PF
08-21-2005 10:31 PM
Dear Pokwan,
Pls Rate the post. It is very importtant for us
Thanks
Swamy
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide