08-18-2005 05:52 PM - edited 03-09-2019 12:11 PM
Hi,
Adding a new FSWM interface
Currently on the Catalyst 6500, this is defined for the active FWSM
firewall module 1 vlan-group 1
firewall vlan-group 1 100,101
If vlan 102 is a new interface for the FWSM, by just entering the command below
will not cause any interruptions to the existing interface vlan 100 and 101.
firewall vlan-group 1 100,101,102
Please confirm.
Debug command
The debug and capture on FWSM do not seemed to work properly. Anyone know if there is a known bug on FWSM version 2.2(1)? If there is, is there a fixed yet?
TIA.
PF
08-18-2005 11:22 PM
Hi,
For adding vlan 102 there is no need to include VLANs 100 & 101 in the command as these were added already.
"firewall vlan-group 1 102" should add the new VLAN without any interruptions to VLANS 100 & 101.
HTH
Regards,
Shijo George.
08-21-2005 02:11 PM
Thanks Shijo.
PF
08-21-2005 10:31 PM
Dear Pokwan,
Pls Rate the post. It is very importtant for us
Thanks
Swamy
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: