cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1640
Views
0
Helpful
1
Replies
ivanov.arseniy
Beginner

Example of ISG PBHK configuration

Could anyone share an example of ISG's PBHK configuration, pretty please?
 
i'm facing an issue when applying PBHK within the subscriber policy. Here is what i do:
 
policy-map type service PBHK
 ip portbundle
!
policy-map type control ISG
 class type control always event session-start
  1 service-policy type service name PBHK
  10 service-policy type service name S_L4R
 !
 class type control always event session-restart
  1 service-policy type service name PBHK
  10 service-policy type service name S_L4R
 !
 class type control always event account-logon
  10 authenticate aaa list RAD_SRV
 
access-list 100 permit ip any host 192.168.8.227
 
ip portbundle
 length 5
 match access-list 100
 source GigabitEthernet2
 
interface GigabitEthernet1
 description endhosts
 ip address 192.168.0.254 255.255.255.0
 ip helper-address vrf SRV 192.168.8.228
 service-policy type control ISG
 ip subscriber l2-connected
  initiator unclassified mac-address
 
interface GigabitEthernet2
 description server-dhcp-int_gw
 vrf forwarding SRV
 ip address dhcp
 ip portbundle outside
 
When i enable the network interface on the end host i see whole bunch of debug messages saying:
 
Portbundle Hostkey: Apply inbound direction from Service Profile configuration
Portbundle Hostkey[uid:33]: No free port-bundles - feature failed
Portbundle Hostkey[uid:33]: Key update: remove port-bundle 0.0.0.0:0
Portbundle Hostkey[uid:33]: Sent a PBHK session key remove
 
How can it be out of ports, if none of  them are used?
 
ISG#show ip portb sta
Bundle-length = 5
Bundle-groups: -
IP Address               Free Bundles       In-use Bundles
192.168.8.230            2016               0
Best regards, Arseniy S. Ivanov
1 REPLY 1
Manuel Rodriguez
Cisco Employee

Hi Arseniy,

 

I think the issue here may be that the PBHK source interface is in a VRF (SRV) different than the VRF of the interface where subscriber arrives (global).

 

I would suggest to change the PBHK source to use an interface not in a VRF. Perhaps use a loopback interface for that. You should still be able to configure ' ip portbundle outside' on the desired interface in VRF SRV.

 

Hope this helps.

Content for Community-Ad