Dear All,
SCE 8000 (System version: Version 3.6.5 Build 489).
I have a problem with SCE behaviour regarding Gy session.
Here is a test stand: SCE (172.24.7.17) should communicate through Daimeter with Gy Server(172.24.4.137).
Problem here is that when subscriber log-in through Radius-LEG SCE send CCR (TERMINATION_REQUEST, CAUSE=DIAMETER_LOGOUT) instead of CCR(INITIAL_REQUEST).
However, as far i know SCE should send exactly CCR(INITIAL_REQUEST).
Settings:
1. Quota request upon login in SCA BB is set to true;
2. Diameter stack is UP and communicate normally, sh diameter peer-table (State is UP).
3. WatchDog goes normally.
4. Log is attached.