Other Service Provider Subjects

as shown in the attached pic,i wish to allow my 2 towns to have internet access  when one town is down the other can pass through the other and have internet access,the protocol in use is BGP Protocol that i use to communicate with my Provider.The r...

Dear AllI have 7200 router, it was runing 124-4.XD3 IOS, the CPU was working normal avarage around 15%, its use for L2TP users, it was have avarage 2000 concurrent L2TP connection, there was no CPU consuming.Then for business plan we change the IOS t...

Can any body help me out in designing a new LDI setup with atleast 2-international and 20-local pops...Any solution Cisco offers or any third party VOIP switches such as Huawei, Nextone etc....An integrated solution will also be off much help..

I am trying to configure MP-BGP to advertise V6 prefixes via a V4 peering session. I was able to make this workutilizing a non VRF configuration and address families. The solution requires dual stack configuration on the peering interface for V6prefi...

If an owner of a building bought a 100Mbps circuit for his building so his tenants could buy better Internet service from him than what they are able to get on their own which fiber port switch would you recommend he use to distribute bandwidth to cu...

Hi,I found some records in the RPT_GUR table but it isn't clear to me when the Generic Usage RDRs are generated and if they can be enabled/disabled.I am using SCOS 3.6.5.Can anyone help me on this ?Thanks,Marco

hello,our reporting DB is corupted (see log report bellow). where can I founde ASE errorlog? Aug  5 10:17:50 SCEserver-01-BB1 sybase_init: 00:00000:00001:2011/08/05 10:17:50.54 server  Error: 926, Severity: 14, State: 1Aug  5 10:17:50 SCEserver-01-BB...

Hello everyone,Does there is an OID which contains subinterface utilization of a physical interface?Best Regards,Begad Ahmed

Is it possible that Cisco router collects traffic statistcics (value of traffic counter of interface at given intervals) from interface and store it localy so it can be fetched lateror deliver to some ftp server or simmilar?

Hi All,I am trying to redirect traffic on C3550 switch for one of the customer from alternate upstream internet link but not able to do so.Attached herewith the topology, customer is connected on fa0/4 & 2 upstream internet links are on gi0/1 & gi0/2...

With Chris Ward Welcome to the Cisco Support Community Ask the Expert conversation.This is an opportunity to learn about Cisco's new Hosted Collaboration Solution architecture and deployment with Cisco expert Chris Ward. Chris is a technical marketin...

HIDear allI have a problem of    understanting the concept of LINE CARD on a router. On our network we   are running C7203 and C7209 routers. The maximum sessions are :• Maximum number of IP and PPPoE subscriber sessions supported per line card is 16...

I am using the command "sceconf.sh --op=list" to display the rate of the RDRs that the CM receives from SCEs.Both "rate" and "peak" are displayed. It isn't clear to me how these values are calculated and if it is possible to reset these counters.Than...

Hi,We are an ISP and have lots of DSL customers. We have taken various External /24 IP pools for the customers and our uplink provider has assigned the bandwidth on these pools.The total bandwidth available to us from the uplink provider is 150MB.The...

I am trying to use the command prunetable.sh but it doesn't work.The command is the following:-----------------------------------------------bash-3.2$ ./prunetable.sh 85 INI_VALUESAre you sure you want to prune table INI_VALUES ? (yes/no): yesPeriodi...