Other Topics - Small Business

Hi how are you?I need help to try it install this CUE on my router, this is error the module show me when I try it to open:DESMS-ROUTER#service-module In2/0 sessionTrying 192.168.1.222, 2131 ... OpenNpx1 Apm Err Dbg Enb App MemReduce MemSync1 Ext Mem...

Hi,My PoD is just working fine. I am trying to send CoA from CPAR 9.2 to Juniper BNG. 9 out of 10 times gives me CoA-NAK witherror code: 503—Session Context Not FoundEven though the session Id exists on BNG

I own a SG350-Port 20 Managed Switch.  I recently upgrade my firmware from v2.5.5.47 to 2.5.9.15, with the firmware itself, allowing me to log back into the device.  However, after the upgrade, my network stopped working.  After reloading my startup-...

I have a strange issue that surfaced yesterday.  All devices on the LAN can print when connected to a wired port, but for laptops when unplug the Cat 5, then suddenly I cannot print.  Everything else (websites, e-mail) all work fine.  When on the WiF...

I purchased a 3 pack of 140ac access points with plans of buying up to 10 more to replace my current enGenius AP network.  I connected the first unit to my network and waited for initial config to complete, then proceeded to follow instructions to co...

Hi,I've followed the steps described herehttps://ciscobusiness.cisco/cbwhelpfiles/help/content/index.html#!c_adding_mesh_extenders.html?highlight=Mesh%20exIn order to include a 143AC mesh extender being a CBW140AC-E the primary Access point.Following...

Hi All,I am trying to replace an old 800 series router with a new ISR 900 series. I am trying to implement the class maps and policy maps. The syntax no longer has "type inspect" for class maps which is fine. However, for policy map, I cannot find th...

Dears,I' have 2 Cisco ASA 5580-20 working as active-standby with 8.2(2) versionone of them is restarting it self every couple of months . I've searched the logs, but can't find any helpful informationis there any thing can i do to solve the problem ?...

I need to know about the screens compatible with cisco equipment.A brand requested by the customer for use in a meetinghouse, such as Samsung QM65R or QM65N.I stay tuned for comments.William Guevara (506)8868-1133

Have no idea where to post the following. I am constantly receiving emails from Cisco Community that have nothing to respond to.  From Cisco Community <ciscocommunity-donotreply@cisco.com> Did you get the answer you needed? Cisco Community   Hello ${...

I am a new user of this system that was installed 5+ years ago and I can find no notation of the PIN for my voicemail. Is there a way to reset the existing PIN so I can use my voicemail? Hopefully, it's not an administrator only function, as I'm not ...

Please for your help, I have installed on my server the Cisco Unified CM  with System version  10.5.2  and for an unknown reason to me, some External Phone Number Masks are not working ( 1 week ago were working fine ) also every new phone number that...

I have 250 branches all over the Republic. And now I have to modernizate Cisco 1861 to smth newer Router. Which routers' model and characteristic advice me?thanks beforenote: every branches have maximum 80 staffs

Good day All, I have and RV082 with approx 50 er so VPN's coming into it. Unfortunately, as vpn's were added to the router, nothing was alphabetical. Is there a way to alphabetize the list on the VPN page?  Would make life a wee bit simpler. Thanks