CMX 10.2.3

[moh_efrangi]

Dear 's 

i have a CMX virtual version 10.2.3 and Cisco WLC 5520 , i import the MAP and exported by using prime and i added the WLC and it give active 

but now i am so confused cause i cannot find a helpful  document about this subject so my Question as below :

1) i used the location not presence so do i need to use prime or not and if i need is there any document for that 

2)after i add the controller i cannot see any access point , do i need any configuration for that from the WLC side and CMX ? if yes is there any document 

3) for client and Heat map the same i cannot see any thing ? is there any document for that 

guys it's i am struggling here any helpful document will be nice

thanks

mohammed  

[Rasika Nayanajith]

1) i used the location not presence so do i need to use prime or not and if i need is there any document for that 

You need Cisco PI to import maps to CMX location.

2)after i add the controller i cannot see any access point , do i need any configuration for that from the WLC side and CMX ? if yes is there any document 

You need to synchronize controller information to CMX.

Refer below post as you may find some useful information

https://mrncciew.com/2016/06/10/cisco-cmx-10-2-part-2/

HTH

Rasika

***Pls rate all useful responses ***

[moh_efrangi]

HI Rasika;

thanks a lot your post really help me , but it's the same issue i cannot see any access point 

do i need to add the access point to the PI and after that exporting the map 

thanks 

[Andrew MacTaggart]

Hi

Assuming you have configured CMX and controller already

As far as I know

Prime is currently used only for maps.

so import map, size correctly, add APs to map and then export maps.

Import map to cmx and you will see clients in CMX.

[cmxadmin@CMX ~]$ cmxctl config maps import

you can choose to import a file or directly from PI

A

[moh_efrangi]

Hi Andrew

thanks for your answer i already exported the map's , but without using any AP ,i install PI just for that without any configuration or adding any access point 

is it possible to work like that 

thanks 

[Andrew MacTaggart]

Hi

Add controller to PI

Add map

Add APs and place APs to map

and then export

in CMX the APs will display numbers which indicates # of clients connected

A