cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

248
Views
0
Helpful
0
Replies
Highlighted

HREAP Question about state office deployment

Good morning to all,

I have finished the preliminary work in our lab and I think I'm ready to deploy. However a coworker brought up an interesting point that I couldn't answer.

I'm creating a small /29 scope on the state office router 192.168.1.0/29  for the access points and PATting them out the serial interface over the wan.

The AP registers without a hickup to the controller and its reported to WCS. since the ip address of the access point is PAT'd and comes back to the central office as the serial IP of the state office can I use the same 192.168.1.0/29 in all of the state offices ?  I suspect the answer is no as WCS does see the actual 192.168.1.1 address of my lab access point. This would make depolyements much simpler.

Everyone's tags (2)
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards