01-14-2019 06:10 PM - edited 07-05-2021 09:41 AM
i just bought a WLC 3504 device, after completion at the process setup wizard. then i can't enter the web based controller stage, with ip management that i have set.
how can i enter this section.? for the switch i have set it to trunk mode
Solved! Go to Solution.
01-14-2019 06:30 PM
If you set a vlan for management interface in initial setting make sure it is not the native vlan on that trunk port.
with that you should be able to ping/GUI access the wlc.
HTH
Rasika
01-14-2019 06:30 PM
If you set a vlan for management interface in initial setting make sure it is not the native vlan on that trunk port.
with that you should be able to ping/GUI access the wlc.
HTH
Rasika
01-14-2019 08:33 PM
01-14-2019 08:41 PM
01-14-2019 08:58 PM
01-14-2019 11:12 PM
Solved
by changing the native vlan according to the existing trunk vlan and access https://ip address
Thanks @Rasika Nayanajith
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide